Posts tagged ‘Standheizung’

Eberspächer heater 24V to 12V conversion

The previous owner of our boat installed an Eberspächer Air heater, which was meant for a lorry, and therefore 24V. Our boat only has 12V Batteries / Alternator. As far as I know he used another battery in series with the auxiliary battery to power the heater, but this battery obviously wasn’t charged when using the heater – I didn’t like that solution, the heater wasn’t used for about 10 years, and now I’ve decided to build a solution.

DSC00040

 

Idea:
The heater has a small controller unit + the heater itself. My idea was to find a 12V to 24V step up converter, and run everything on 24V. This didn’t work out, as I didn’t find an affordable 12V to 24V converter, the one I bought said 150W output power, but that just isn’t enough for the initial glow.

2nd idea:
I thought, why not just replace the glow plug, with a 12V version (didn’t know if it exists back than), and use a relay to switch a 12V line with the 24V from the controller unit.

Doing it:
At this point I’ve decided to unmount the heater, as i needed to find out what kind of unit I have, and which glow plug I actually needed.

What I found was even better:
There’s a huge resistor (or call it a spring) in series with the glow plug – the glow plug is actually a 12V plug, you just need to rewire it to not use the resistor, and install the relay as mentioned above (I obviously don’t know if this is with all the Eberspächer heaters, but it’s worth looking).

Resistor:

DSC00032

Open controller unit:

DSC00034

Controller unit with attached step up converter + relays:

 

 

DSC00036

DSC00035

Close-up of the modification:
DSC00038

The yellow line goes to the glow plug (already connected directly on the picture, the yellow line in the background goes to the resistor and back):
DSC00041